Audio Technica AT-VM95C Handmade Head Elliptical Pin for Half-Inch Turntable
Audio Technica AT-VM95C Handmade Head Elliptical Pin for Half-Inch Turntable
The Audio Technica VM95 series of heads with 0.3 x 0.7 mm elliptical spike (diamond) fits any half-inch turntable. All needles in the series have the same body, aluminum stem, metal nests for screws for easy mounting, the patented system with the two magnets that resemble the V-shape of the cutting machine head and are sold either with head or flat. As they share the same body they are fully compatible and interchangeable.
Audio Technica released the VM95 series in late 2018 by upgrading the fantastic AT95 series of heads and improving it with a range of interchangeable needles from the "silver" conical to the top performance Shibata. This head houses an elliptical diamond needle with the AT95E logic successor but with a more easy mounting process and the ability to upgrade the needle with any other in the range from the bare diamond ellipse to the Shibata at a later time if desired.
The AT95e has an elliptical diamond and a double magnet. The high frequencies are reproduced with astonishing clarity and the bass is powerful and accurate. The VM95E, the new model of Audio-Technica Elliptical, will replace the legendary AT95E and take advantage of the AT95EX developments produced in 2015.
The AT-VM95E has an improved and distinctive design that results in a more rigid low-resonance housing, and two screw inserts in the head body that allow it to be mounted on the Shell with just two screws, without nuts. It can be used on a wide variety of turntables, and with a wide variety of musical tastes.
The product comes in factory packaging, sealed with Audio Technica security tape
Available upon request
Delivery 1-3 working days depending on availability
For Phone Order call 210-8838004 and mention the Product Code
Manufacturer's technical information
- Type: Dual Magnet.
- Output: 4 mV.
- Recommended Resistance: 485Ω
- No returns of heads and needles are accepted
Model | AT-VM95E |
Type | VM Stereo Dual Magnet |
Mounting | 1/2” centres |
Frequency Response | 20 - 22,000 Hz |
Channel Separation | 20 dB (1 kHz) |
Output Channel Balance | 2.0 dB (1 kHz) |
Output Voltage | 4.0 mV (@ 1 kHz, 5 cm/sec) |
Vertical Tracking Angle | 23° |
Vertical Tracking Force Range | 1.8 - 2.2g (standard 2.0 g) |
Stylus Shape | Elliptical |
Stylus Size | 0.3 x 0.7 mil |
Stylus Construction | Bonded Round Shank |
Cantilever | Aluminium Pipe |
Coil Impedance | 3.3 kΩ (1 kHz) |
Coil Inductance | 550 mH (1 kHz) |
DC Resistance | 485 Ω |
Static Compliance | 17 x 10 – 6 cm / dyne |
Dynamic Compliance | 7 x 10 – 6 cm / dyne (100 Hz) |
Wire Used for Coil | T.P. Copper |
Recommended Load Impedance | 47,000 Ω |
Recommended Load Capacitance | 100-200 pF |
Cartridge Weight | 6.1g |
Dimensions | 17.2 x 18.9 x 28.3 ( H x W x D mm) |
Replacement Stylus | AT-VMN95E |
Accessories Included | Two 11 mm installation screws; Two 8 mm installation screws; Two washers |
No posts found